GD25Q128C Datasheet, PDF (54/69 Pages) ELM Electronics – 128M-bit Serial Flash

GD25Q128CxIGx 3.3V Uniform Sector Dual and Quad Serial Flash
7.34. Burst Read with Wrap (0CH)
http://www.elm-tech.com
The “Burst Read with Wrap (0CH)” command provides an alternative way to perform the read operation with
“Wrap Around” in QPI mode. This command is similar to the “Fast Read (0BH)” command in QPI mode, except
the addressing of the read operation will “Wrap Around” to the beginning boundary of the “Wrap Around” once
the ending boundary is reached. The “Wrap Length” and the number of dummy clocks can be configured by the
“Set Read Parameters (C0H)” command.
Figure 40. Burst Read with Wrap command Sequence Diagram
CS#
SCLK
IO₀
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14
Command
0CH
20 16 12 8 4 0
IOs switch from
Input to output
4 04 0 4
IO₁
21 17 13 9 5 1
5 15 1 5
IO₂
22 18 14 10 6 2
6 26 2 6
IO₃
23 19 15 11 7 3
7 37 3 7
A23-16
A15-8
A7-0
Dummy*
Byte1
Byte2
Byte3
*"Set Read Parameters" Command (C0H)
can set the number of dummy clocks
7.35. Enable QPI (38H)
The device support both Standard/Dual/Quad SPI and QPI mode. The “Enable QPI (38H)” command can
switch the device from SPI mode to QPI mode. See the command Table 7.2. for all support QPI commands. In
order to switch the device to QPI mode, the Quad Enable (QE) bit in Status Register-1 must be set to 1 first,
and “Enable QPI (38H)” command must be issued. If the QE bit is 0, the “Enable QPI (38H)” command will
be ignored and the device will remain in SPI mode. When the device is switched from SPI mode to QPI mode,
the existing Write Enable Latch and Program/Erase Suspend status, and the Wrap Length setting will remain
unchanged.
Figure 41. Enable QPI mode command Sequence Diagram
CS#
SCLK
01234567
Command
SI
38H
69 - 54
Rev.1.2