BCM43353LIUBGT Datasheet, PDF (79/143 Pages) Cypress Semiconductor – Single-Chip 5G WiFi IEEE 802.11ac MAC/Baseband/Radio with Integrated Bluetooth 4.1 for Automotive and Industrial Applications

BCM43353 Data Sheet
Signal Descriptions
Signal Descriptions
The signal name, type, and description of each pin in the BCM43353 is listed in Table 15. The symbols shown
under Type indicate pin directions (I/O = bidirectional, I = input, O = output) and the internal pull-up/pull-down
characteristics (PU = weak internal pull-up resistor and PD = weak internal pull-down resistor), if any.
Table 15: WLBGA Signal Descriptions
WLBGA
Ball#
Signal Name
Type Description
WLAN and Bluetooth RF Signal Interface
N7
WRF_RFIN_2G
N5
BT_RF_TX
N12
WRF_RFIN_5G
N8
WRF_RFOUT_2G
N11
WRF_RFOUT_5G
J7
WRF_TSSI_A
H7
WRF_RES_EXT/
WRF_GPIO_OUT/
WRF_TSSI_G
I 2.4 GHz Bluetooth and WLAN
receiver shared input.
O Bluetooth PA output.
I 5 GHz WLAN receiver input.
O 2.4 GHz WLAN PA output.
O 5 GHz WLAN PA output.
I 5 GHz TSSI input from an
optional external power
amplifier/power detector.
I/O GPIO or 2.4 GHz TSSI input
from an optional external power
amplifier/power detector.
RF Switch Control Lines
F12
F11
E12
E11
D12
F8
H9
G7
E10
F5
RF_SW_CTRL_0
RF_SW_CTRL_1
RF_SW_CTRL_2
RF_SW_CTRL_3
RF_SW_CTRL_4
RF_SW_CTRL_5
RF_SW_CTRL_6
RF_SW_CTRL_7
RF_SW_CTRL_8
RF_SW_CTRL_9
O Programmable RF switch
O
control lines. The control lines
are programmable via the
O _{driver and NVRAM file.}
O
O
O
O
O
O
O
WLAN SDIO Bus Interface
Note: These signals can also have alternate functionality depending on host interface mode. Refer to
Table 21: “BCM43353 GPIO/SDIO Alternative Signal Functions,” on page 88 for additional details.
B11
SDIO_CLK
I SDIO clock input.
B12
SDIO_CMD
I/O SDIO command line.
B10
SDIO_DATA_0
I/O SDIO data line 0.
C10
SDIO_DATA_1
I/O SDIO data line 1.
D10
SDIO_DATA_2
I/O SDIO data line 2.
C11
SDIO_DATA_3
I/O SDIO data line 3.
Broadcom^®
November 14, 2014 • 43353-DS104-R
Page 78