BCM43353LIUBGT Datasheet, PDF (102/143 Pages) Cypress Semiconductor – Single-Chip 5G WiFi IEEE 802.11ac MAC/Baseband/Radio with Integrated Bluetooth 4.1 for Automotive and Industrial Applications

BCM43353 Data Sheet
Bluetooth RF Specifications
Table 28: Bluetooth Transmitter RF Specifications (Cont.)
Parameter
Conditions
Minimum Typical Maximum Unit
Out-of-Band Spurious Emissions
30 MHz to 1 GHz
–
1 GHz to 12.75 GHz
–
1.8 GHz to 1.9 GHz
–
5.15 GHz to 5.3 GHz
–
–
–
–36.0 ^{c, d dBm}
–
–
–30.0 ^{b, e, f dBm}
–
–
–47.0
dBm
–
–
–47.0
dBm
GPS Band Spurious Emissions
Spurious emissions
–
–
–103 –
dBm
Out-of-Band Noise Floor^g
65–108 MHz
776–794 MHz
869–960 MHz
925–960 MHz
1570–1580 MHz
1805–1880 MHz
1930–1990 MHz
2110–2170 MHz
2500–2570 MHz
2300–2400 MHz
2570–2620 MHz
2545–2575 MHz
FM RX
–
CDMA2000
–
cdmaOne, GSM850
–
E-GSM
–
GPS
–
GSM1800
–
GSM1900, cdmaOne, WCDMA –
WCDMA
–
Band 7
–
Band 40
–
Band 38
–
XGP Band
–
–147 –
–147 –
–147 –
–147 –
–146 –
–145 –
–144 –
–141 –
–140 –
–140 –
–140 –
–140 –
dBm/Hz
dBm/Hz
dBm/Hz
dBm/Hz
dBm/Hz
dBm/Hz
dBm/Hz
dBm/Hz
dBm/Hz
dBm/Hz
dBm/Hz
dBm/Hz
a. Output power will be 1 dB lower at temperatures between –15°C and –40°C.
b. The typical number is measured at ±3 MHz offset.
c. The maximum value represents the value required for Bluetooth qualification as defined in the v4.1 specification.
d. The spurious emissions during Idle mode are the same as specified in Table 28 on page 100.
e. Specified at the Bluetooth Antenna port.
f. Meets this specification using a front-end band-pass filter.
g. Transmitted power in cellular at the Bluetooth Antenna port. See Figure 31 on page 96 for location of the port.
Broadcom^®
November 14, 2014 • 43353-DS104-R
Page 101