LUPA-4000_07 Datasheet, PDF (7/38 Pages) Cypress Semiconductor – 4M Pixel CMOS Image Sensor

LUPA-4000
Table 3. Features and general specifications (continued)
Feature
Output amplifiers
External output load
Number of outputs
Specification/Description
Differential
R > 10 kΩ
C < 20 pF (<10 pF is advised)
1 at 66 Mpixels/sec
2 at 33 Mpixels/sec
Electrical specifications
Absolute maximum ratings
VDD DC supply voltage -0.5 to 4.5 V
V_IN DC input voltage -0.5 to 3.8 V
V_OUT DC output voltage -0.5 to 3.8 V
I_IO DC current drain per pin; any single input
Recommended operating conditions
or output. ± 50 mA
T_L Lead temperature (5 seconds soldering). 350 °C
• Absolute Ratings are those values beyond which damage
to the device may occur.
• VDD = VDDD = VDDA (VDDD is supply to digital circuit,
VDDA to analog circuit).
Table 4. Recommended operation conditions
Symbol
Parameter
Min.
Typ.
Max.
Unit
Vaa
Power supply column read out module
2.5
V
Va3
Power supply column read out module
3.3
3.3
V
Vdd
Power supply digital modules
2.5
V
Voo
Power supply output stages
2.5
V
Vres
Power supply reset drivers
2.5
3.5
3.8
V
Vres_ds
Power supply multiple slope reset driver
2.0
2.5
3.3
V
Vmem_h
Power supply memory element (high level)
2.5
3.3
3.5
V
Vmem_l
Power supply memory element (low level)
2.0
2.6
3.0
V
Vpix
Power supply pixel array
2.0
2.6
3.3
V
Vpre_l
Power supply for Precharge off-state
–0.4
0
0
V
T_A
Commercial operating temperature.
0
30
60
°C
Notes
1. All parameters are characterized for DC conditions after thermal equilibrium has been established.
2. Unused inputs must always be tied to an appropriate logic level, e.g. either VDD or GND.
3. This device contains circuitry to protect the inputs against damage due to high static voltages or electric fields; however it is recommended that normal precautions
be taken to avoid application of any voltages higher than the maximum rated voltages to this high impedance circuit.
Document Number: 38-05712 Rev. *B
Page 7 of 38