LUPA-4000_07 Datasheet, PDF (35/38 Pages) Cypress Semiconductor – 4M Pixel CMOS Image Sensor

LUPA-4000
Handling and soldering precautions
Special care should be given when soldering image sensors
with color filter arrays (RGB color filters), onto a circuit board,
since color filters are sensitive to high temperatures.
Prolonged heating at elevated temperatures may result in
deterioration of the performance of the sensor. The following
recommendations are made to ensure that sensor perfor-
mance is not compromised during end-users' assembly
processes.
Board Assembly:
Device placement onto boards should be done in accordance
with strict ESD controls for Class 0, JESD22 Human Body
Model, and Class A, JESD22 Machine Model devices.
Assembly operators should always wear all designated and
approved grounding equipment; grounded wrist straps at ESD
protected workstations are recommended including the use of
ionized blowers. All tools should be ESD protected.
Manual Soldering:
When a soldering iron is used the following conditions should
be observed:
• Use a soldering iron with temperature control at the tip.
• The soldering iron tip temperature should not exceed
350°C.
• The soldering period for each pin should be less than 5
seconds.
Precautions and cleaning:
Avoid spilling solder flux on the cover glass; bare glass and
particularly glass with antireflection filters may be adversely
affected by the flux. Avoid mechanical or particulate damage
to the cover glass.
It is recommended that isopropyl alcohol (IPA) is used as a
solvent for cleaning the image sensor glass lid. When using
other solvents, it should be confirmed beforehand whether the
solvent will dissolve the package and/or the glass lid or not.
Ordering Information
FillFactory Part Number
LUPA-4000-M
Cypress Semiconductor
Part Number
CYIL1SM4000AA-GBC
Disclaimer
The LUPA-4000 is only to be used for non-military
applications. A strict exclusivity agreement prevents us to sell
the LUPA-4000 to customers who intend to use it for military
applications.
FillFactory image sensors are only warranted to meet the
specifications as described in the production data sheet.
Specifications are subject to change without notice.
Please contact [e-mail] for more information.
Document Number: 38-05712 Rev. *B
Page 35 of 38