SM3G Datasheet, PDF (34/36 Pages) Connor-Winfield Corporation – ULTRA MINIATURE STRATUM 3 MODULE

Figure 15
Optional Programing Header Reference Design
GND
J2
1 _NC
3 _NC
5 _NC
7 _GND
9 _GND
11 _GND
13 _NC
15 _NC
17 _GND
19 _GND
21 _NC
23 _NC
25 _NC
VDDP ²
VDDP ⁴
VPP ⁶
VPN ⁸
GND ¹⁰
TCK ¹²
TDI ¹⁴
TDO ¹⁶
TMS ¹⁸
RCK ²⁰
TRST ²²
VDD ²⁴
VDD ²⁶
FTSH-113-01-L-D-K
SAMTEC
4.7uF
C5
VPP
VPN
GND
TCK
TDO
TDI
TMS
TRST
4.7uF
C6
4.7uF (low ESR, <1W, Tantalum,
25V or greater rating)
*Not required if header
is not installed.
VCC
The programming header is optional. It provides a means
for re-programming the chip on board if necessary.
The SAMTEC header has a notch and should be laid out in
such a way that the notch is on the pin1 side. The
header specified here is a thru-hole part and surface
mount versions are available. Please refer to
www.samtec.com for more information on the header.
Ordering Information
SM3G-XXX.XXM
Replace XXX.XX with one of the following available frequencies,
012.96MHz, 019.44MHz, 025.92MHz, 038.88MHz, 051.84MHz or 077.76MHz.
Please contact Connor-Winfield for other frequencies that may be available.
Similar Products from Connor-Winfield
SM3-8R-XXX.XXM - Stratum 3 module with 8 input references.
SM3-IT-XXX.XXM - Industrial temperature rated Stratum 3 module with 4 input references.
SM3E-XXX.XXM - Stratum 3E module with 8 input references.
SM3G5 Data Sheet #: TM083 Page 34 of 36 Rev: 05 Date: 01/26/11
© Copyright 2011 The Connor-Winfield Corp. All Rights Reserved Specifications subject to change without notice