CS42325 Datasheet, PDF (48/71 Pages) Cirrus Logic – 10-In, 6-Out, 2 Vrms Audio CODEC with Headphone

6.3.2
CS42325
INT Pin High/Low Active (INT_H/L)
When this bit is set, the INT pin will function as an active high CMOS driver. When this bit is cleared, the
INT pin will function as an active low open drain driver and will require an external pull-up resistor for prop-
er operation.
INT_H/L
0
1
Active low, open drain driver
Active high, CMOS driver
INT Pin Polarity
6.3.3
Freeze
This function allows modifications to be made to certain bits without the changes taking effect until the
Freeze bit is disabled. To make multiple changes to these bits take effect simultaneously, set the Freeze
bit, make all changes, then clear the Freeze bit. The bits affected by the Freeze function are listed in
Table 10.
FREEZE
0
1
FREEZE Status
Changes to registers take effect immediately
Changes to registers are held until FREEZE is released
Name
Mute Control
ADC Ch A Vol. Control
ADC Ch B Vol. Control
DAC1 Ch A Vol. Control
DAC1 Ch B Vol. Control
DAC2 Ch A Vol. Control
DAC2 Ch B Vol. Control
Register
01h
0Fh
10h
11h
12h
13h
14h
Table 10. Freeze-able Bits
Bit(s)
7:0
7:0
7:0
7:0
7:0
7:0
7:0
6.3.4
Tri-State SDOUT
When this bit is set, SDOUT will be placed in a high-impedance state.
TRI-SDOUT
0
1
Output
High-impedance
SDOUT state
6.3.5
Tri-State Serial Port 1
When enabled, and the device is configured as a master, then SCLK1 and LRCK1 of Serial Port 1 (SP1)
will be placed in a high-impedance output state. If Serial Port 1 is configured as a slave, SCLK1 and
LRCK1 will remain as inputs.
TRI-SP1
0
1
SCLK1 and LRCK1 State
SCLK1 and LRCK1 operate as inputs if Serial Port 1 is configured as a slave; SCLK1 and LRCK1
operate as outputs if Serial Port 1 is configured as a master
SCLK1 and LRCK1 operate as inputs if Serial Port 1 is configured as a slave; SCLK1 and LRCK1
become high-impedance outputs if Serial Port 1 is configured as a master
48
DS838A2