CDB4923 Datasheet, PDF (40/50 Pages) Cirrus Logic – Evaluation Board

CDB4923 CDB49300
* = default
EXAMPLES:
cdb23cmd 000001 -p3bc
cdb23cmd -fac3.cfg -mS -p3bc
CDB30_RD - program used to read back responses from the CS492x/CS493xx. If the INTREQ
pin is not low when CDB30_RD is executed, the program will wait until INTREQ
drops. Press the ‘Enter’ key to exit the read wait loop.
Usage:
cdb30_rd [-pXXX] [-mY] [-v] [-h]
-p = parallel port address
XXX = address (0x278, 378* or 3bc)
-m = communication mode
Y = mode designator (i = I2C*, s = SPI, m=MOT, n=INT)
-v = disable verbose mode
-h = this message
* = default
CDB30RST - program used to perform hard reset or soft reset on the CS492x/CS493xx.
Usage:
cdb30rst [-s] [-pXXX] [-mY] [-v] [-h]
-s = Soft Reset
-p = parallel port address
XXX = address (0x278, 378* or 3bc)
-m = communication mode
Y = mode designator (i = I2C*, s = SPI, m=MOT, n=INT)
-v = disable verbose mode
-h = this message
* = default
PARLLPLY - program used to deliver compressed audio files to the parallel host port
of the CS492x/CS493xx from the PC.
Usage:
parllply <input_file> [-pXXX] [-mY] [-l] [-b] [-cNNN]
-p = parallel port address
XXX = address (0x278, 378* or 3bc)
-l = Loop Mode
-b = Byte Swap
40
DS262DB2