EP2S180 Datasheet, PDF (41/58 Pages) Altera Corporation – DSP Development Board

Altera Corporation
Board Components & Interfaces
Table 2–26. Ethernet MAC/PHY (U16) (Part 3
of 3)
Pin Name
SE_D25
SE_D26
SE_D27
SE_D28
SE_D29
SE_D30
SE_D31
Pin Number
AL28
AK28
AK29
AC13
AD10
AC11
AE11
Table 2–27 lists the reference information for the Ethernet MAC/PHY.
Table 2–27. Ethernet MAC/PHY Reference
Item
Board reference
Part Number
Device description
Manufacturer
Manufacturer web site
Description
U16
LAN91C111-NE
Ethernet MAC/PHY
SMSC
www.smsc.com
CompactFlash Connector (CON1)
The CompactFlash connector header (CON1) enables hardware designs
to access a CompactFlash card. The following two access modes are
supported:
■ ATA (hot-swappable mode)
■ IDE (IDE hard-disk mode)
Most pins of CON1 connect to I/O pins on the FPGA. The following pins
have special connections:
■ Pin 13 of CON1 (VCC) is driven by a power MOSFET that is
controlled by an FPGA I/O pin. This allows the FPGA to control
power to the CompactFlash card for the IDE connection mode.
■ Pin 26 of CON1 (CD1#) is pulled up to 5V through a 10-KΩ resistor.
This signal is used to detect the presence of a CompactFlash card.
When the card is not present, the signal is pulled high through the
pull-up resistor.
Core Version a.b.c variable
2–33
Stratix II EP2S180 DSP Development Board Reference Manual