EP2S180 Datasheet, PDF (24/58 Pages) Altera Corporation – DSP Development Board

Board Components
Figure 2–4 shows the pin-outs for the 7-segment display.
Figure 2–4. Pin-Out Diagram for the Dual 7-Segment Display
HEX_0A
HEX_1A
HEX_0G
HEX_1G
HEX_0D HEX_0DP
HEX_1D HEX_1DP
A/D Converters
The Stratix II EP2S180 DSP development board has two 12-bit A/D
converters that produce samples at a maximum rate of 125 mega-samples
per second (MSPS). The A/D subsystem of the board has the following
features:
■ The data output format from each A/D converter to the Stratix II
device is in two’s complement format.
■ The circuit has a wideband, AC-coupled, differential input useful for
IF sampling. The analog inputs are transformer-coupled to the A/D
converter to create a balanced input. To maximize performance, two
transformers are used in series. The Analog Devices data sheet for
the AD9433 device describes the detailed operation of this circuit.
■ Any required anti-aliasing filtering can be installed externally. If
needed, users can purchase in-line SMA filters from a variety of
manufacturers, such as Mini-Circuits (www.minicircuits.com).
1
The transformer-coupled AC circuit has a lower 3-dB frequency,
of approximately 1 MHz.
The clock signal that drives the A/D converters can originate from the
Stratix II device, the external clock input, or the on-board 100-MHz
oscillator. Jumper J3 controls which clock is used for ADC A and J4 is used
2–16
Core Version a.b.c variable
Stratix II EP2S180 DSP Development Board Reference Manual
Altera Corporation