Z8PE003 Datasheet, PDF (8/48 Pages) Zilog, Inc. – FEATURE-ENHANCED Z8PLUS 1K ROM ONE-TIME PROGRAMMABLE (OTP) MICROCONTROLLER

Z8PE003
Z8Plus OTP Microcontroller
ABSOLUTE MAXIMUM RATINGS
Parameter
Min
Ambient Temperature under Bias
–40
Storage Temperature
–65
Voltage on any Pin with Respect to V_SS
–0.6
Voltage on V_DD Pin with Respect to V_SS
–0.3
Voltage on PB5 Pin with Respect to V_SS
–0.6
Total Power Dissipation
Maximum Allowable Current out of V_SS
Maximum Allowable Current into V_DD
Maximum Allowable Current into an Input Pin
–600
Maximum Allowable Current into an Open-Drain Pin
–600
Maximum Allowable Output Current Sunk by Any I/O Pin
Maximum Allowable Output Current Sourced by Any I/O Pin
Maximum Allowable Output Current Sunk by Port A
Maximum Allowable Output Current Sourced by Port A
Maximum Allowable Output Current Sunk by Port B
Maximum Allowable Output Current Sourced by Port B
Notes:
1. Applies to all pins except the PB5 pin and where otherwise noted.
2. There is no input protection diode from pin to V_DD.
3. Peak Current. Do not exceed 25mA average current in either direction.
4. Excludes XTAL pins.
5. Device pin is not at an output Low state.
Max
+105
+150
+7
+7
V_DD+1
880
40
40
+600
+600
25
25
40
40
40
40
Units
C
C
V
V
V
mW
mA
mA
µA
µA
mA
mA
mA
mA
mA
mA
ZiLOG
Note
1
2
3
3
4
5
3
3
3
3
Stresses greater than those listed under Absolute Maximum
Ratings can cause permanent damage to the device. This rat-
ing is a stress rating only. Functional operation of the device
at any condition above those indicated in the operational
sections of these specifications is not implied. Exposure to
absolute maximum rating conditions for an extended period
can affect device reliability. Total power dissipation should
not exceed 880 mW for the package. Power dissipation is
calculated as follows:
Total Power Dissipation = V_DD x [I_DD – (sum of I_OH)]
+ sum of [(V_DD – V_OH) x I_OH]
+ sum of (V_OL x I_OL)
8
PRELIMINARY
DS007500-Z8X0399