Z8PE003 Datasheet, PDF (43/48 Pages) Zilog, Inc. – FEATURE-ENHANCED Z8PLUS 1K ROM ONE-TIME PROGRAMMABLE (OTP) MICROCONTROLLER

ZiLOG
Z8PE003
Z8Plus OTP Microcontroller
I/O PORT RESET CONDITIONS
Full Reset
Port A and Port B output value registers are not affected by
RESET.
On RESET, the Port A and Port B directional control reg-
isters are cleared to all zeros, which defines all pins in both
ports as inputs.
On RESET, the directional control registers redefine all pins
as inputs, and the Port A and Port B input value registers
overwrites the previously held data with the current sample
of the input pins.
On RESET, the Port A and Port B special function registers
are cleared to 00h, which deactivates all port special func-
tions.
Note: The SMR and WDT time-out events are not full device
resets. The port control registers are not affected by ei-
ther of these events.
ANALOG COMPARATOR
The device includes one on-chip analog comparator. Pin
PB4 features a comparator front end. The comparator ref-
erence voltage is on pin PB3.
Comparator Description
The on-chip comparator can process an analog signal on
PB4 with reference to the voltage on PB3. The analog func-
tion is enabled by programming the Port B special function
register bits 3 and 4.
When the analog comparator function is enabled, bit 4 of
the input register is defined as holding the synchronized out-
put of the comparator, while bit 3 retains a synchronized
sample of the reference input.
If the interrupts for PB4 are enabled when the comparator
special function is selected, the output of the comparator
generates interrupts.
COMPARATOR OPERATION
The comparator output reflects the relationship between the
analog input to the reference input. If the voltage on the an-
alog input is higher than the voltage on the reference input,
then the comparator output is at a High state. If the voltage
on the analog input is lower than the voltage on the reference
input, then the analog output is at a Low state.
Comparator Definitions
V_ICR
The usable voltage range for the positive input and
reference input is called the Comparator Input Common
Mode Voltage Range (V_ICR).
Note: The comparator is not guaranteed to work if the input is
outside of the V_ICR range.
V_OFFSET
The absolute value of the voltage between the positive input
and the reference input required to make the comparator
output voltage switch is the Comparator Input Offset Volt-
age (V_OFFSET).
I_IO
For the CMOS voltage comparator input, the input offset current
(I_IO) is the leakage current of the CMOS input gate.
HALT Mode
The analog comparator is functional during HALT mode. If
the interrupts are enabled, an interrupt generated by the
comparator causes a return from HALT mode.
STOP Mode
The analog comparator is disabled during STOP mode. The
comparator is powered down to prevent it from drawing any
current.
Low Voltage Protection. An on-board Voltage Compar-
ator checks that the V_CC is at the required level to ensure
correct operation of the device. A reset is globally driven
if V_CC is below the specified voltage (Low Voltage Protec-
tion).
The device functions normally at or above 3.0V under all
conditions, and is guaranteed to function normally at supply
voltages above the Low Voltage Protection trip point. Be-
low 3.0V, the device functions normally until the Low Volt-
DS007500-Z8X0399
PRELIMINARY
43