English
Language : 

X9470 Datasheet, PDF (3/25 Pages) Xicor Inc. – RF Power Amplifier (PA) Bias Controller
Preliminary Information
X9470
ABSOLUTE MAXIMUM RATINGS*
Voltage on V+ (referenced to AGND)....................... 7V
Voltage on VCC (reference to VSS)......................... 7V
Voltage on all RH, RW, RL pins
(reference to AGND): ........................................... 7V
Voltage on Vsense+ or
Vsense- (reference to AGRND).......................... 30V
Voltage on SDA, CS, SCL, SHDN
(reference to AGND) ............... -0.3V to (Vcc + 0.3V)
Current into Output Pin: .......................................... ±5mA
Continuous Power Dissipation:........................ 500mW
Operating Temperature range: ...............-40°C to +85°C
Junction Temperature:........................................... 150°C
Storage Temperature......................... -65°C to +150°C
Lead Temperature (Soldering, 10 seconds): ..... 300°C
*COMMENT
Stresses above those listed under “Absolute Maximum
Ratings” may cause permanent damage to the device.
This is a stress rating only and the functional operation
of the device at these or any other conditions above
those listed in the operational sections of this specifi-
cation is not implied. Exposure to absolute maximum
rating conditions for extended periods may affect
device reliability.
ELECTRICAL CHARACTERISTICS
INSTRUMENTATION AMPLIFIER
Recommended Operating Conditions: (Vcc, V+ = 4.75 to 5.25V; Vsense+, Vsense- = 26V; TA = -40°C to +85°C,
unless otherwise noted.)
Symbol
VIN(10)
Gain 1
Gain 2
VRANGE1
VRANGE2
VOS
Av1
Av2
Avt1
Avt2
At
Parameter
Common Mode Input Voltage on
VSENSE+ and VSENSE- pins
Gain from VSENSE to VOUT(2)
Gain from VSENSE to VOUT(2)
Differential voltage sense range be-
tween VSENSE+ and VSENSE- for gain 1
Differential voltage sense range be-
tween VSENSE+ and VSENSE- for gain 2
Input Offset Voltage
Gain 1 Error
Gain = 20 (4)
Gain 2 Error
Gain = 50 (4)
Total Error, Gain 1
Gain = 20 (5)
Total Error, Gain 2
Gain = 50 (5)
Long Term Drift
Limits
Min. Typ. Max. Units
20
28 V
Test Conditions/Notes
20
V/V Measured with Status
Register bit SR0=0
50
V/V Measured with Status
Register bit SR0=1
60 90 mV Gain = 20
40 60 mV Gain = 50
0.5
mV VSENSE = 40mV to 90mV
TA = 25°C
1.5
% VSENSE = 60mV to 90mV
TA = 25 to 85°C, Gain = 20
1.5
% VSENSE = 40mV to 60mV
TA = 25 to 85°C, Gain = 50
-6 1.5 6
10
-6 1.5 6
10
2
% VSENSE = 60mV to 90mV
TA = 85°C, Gain = 20
% VSENSE = 60mV to 90mV
TA = 25 to 85°C, Gain = 20
% VSENSE = 40mV to 60mV
TA = 85°C, Gain = 50
% VSENSE = 40mV to 60mV
TA = 25 to 85°C, Gain = 50
% Avt1 or Avt2
REV 11.16 3/20/03
www.xicor.com
3 of 25