W741C260 Datasheet, PDF (62/92 Pages) Winbond – 4-BIT MICROCONTROLLER

W741C260
Instruction Set Table 2, continued
MOV IEF, #I
Set/Reset Interrupt Enable Flag
Machine Code:
01010001
I7 I6 I5 I4 I3 I2 I1 I0
Machine Cycle:
Operation:
Description:
MOV LCDM, #I
1
Interrupt Enable flag Control
The interrupt enable flag corresponding to the data specified by I7−I0 is
controlled:
I0 to I5 Operation
The IEF0 is set so that interrupt 0 (overflow from the
I0 = 1 _{Divider0) is accepted.}
I1 = 1 ^{The IEF1 is set so that interrupt 1 (underflow from the}
Timer 0) is accepted.
I2 = 1
The IEF2 is set so that interrupt 2 (signal change on port
RC) is accepted.
I3 = 1 Reserved
I4 = 1
The IEF4 is set so that interrupt 4 (overflow from the
Divider1) is accepted.
I5 & I6
I7 = 1
Reserved
The IEF7 is set so that interrupt 7 (underflow from the
Timer 1) is accepted.
Select LCD output Mode type
Machine Code:
00000011
I7 I6 I5 I4 I3 I2 I1 I0
Machine Cycle:
Operation:
Description:
1
Select LCD output mode type
When LCD output pins are set to DC output mode, user can select CMOS
or NMOS as output type.
I0−I7 = 0 => CMOS type; I0−I7 = 1 => NMOS type
- 62 -