W83697HG Datasheet, PDF (47/109 Pages) Winbond – WINBOND LPC I/O

W83697HF/ HG
Bit 4: Enable BEEP output for Temperature Sensor 1 if the monitor value exceed the limit value.
Write 1, enable BEEP output. Default 0
Bit 3: Enable BEEP output from AVCC (+5V), Write 1, enable BEEP output if the monitor value exceed
the limits value. Default 0, that is disable BEEP output.
Bit 2: Enable BEEP output from +3.3V. Write 1, enable BEEP output, which is default value.
Bit 1: Reserved
Bit 0: Enable BEEP Output from VCORE if the monitor value exceed the limits value. Write 1,
enable BEEP output, which is default value
BEEP Control Register 2-- Index 57h (Bank 0)
Register Location:
57h
Power on Default Value 80h
Attribute:
Read/Write
Size:
8 bits
7 6 5 4 32 1 0
EN_V12_BP
EN_NV12_BP
EN_NV5_BP
Reserved
EN_CASO_BP
Reserved
Reserved
EN_GBP
Bit 7: Enable Global BEEP. Write 1, enable global BEEP output. Default 1. Write 0, disable all BEEP
output.
Bit 6: Reserved. This bit should be set to 0.
Bit5: Reserved
Bit 4: Enable BEEP output for case open if case opend. Write 1, enable BEEP output. Default 0.
Bit 3: Reserved
Bit 2: Enable BEEP output from -5V, Write 1, enable BEEP output if the monitor value exceed the
limits value. Default 0, that is disable BEEP output.
Bit 1: Enable BEEP output from -12V, Write 1, enable BEEP output if the monitor value exceed the
limits value. Default 0, that is disable BEEP output.
Bit 0: Enable BEEP output from +12V, Write 1, enable BEEP output if the monitor value exceed the
limits value. Default 0, that is disable BEEP output.
- 44 -