TCM4300 Datasheet, PDF (63/69 Pages) Texas Instruments – Advanced RF Cellular Telephone Interface Circuit (ARCTIC )

4.23 Reset
A low on RSINL causes the TCM4300 internal registers to assume their reset values. The power-on reset
circuit also causes internal reset. However, the logic level at RSINL has no effect on reset outputs RSOUTH
and RSOUTL. The effects of resetting the TCM4300 are described in the following paragraphs.
4.23.1 Power-On Reset
The power-on reset (POR) is digitally implemented and provides a timed POR signal at RSOUTL and
RSOUTH. The POR pulse duration is equal to 388,800 cycles of MCLKIN (10 ms). There are two outputs
to provide a high reset and a low reset in order to accommodate the reset polarity requirements of any
external device. The TCM4300 internal registers are reset when the POR outputs are activated. See
Figure 4–13.
DVDD
RSOUTH
tw
10 ms Minimum
90%
90%
RSOUTL
10%
10%
Figure 4–13. Power-On Reset Timing
4.23.2 Internal Reset State
After power-on reset, the TCM4300 register bits are initialized to the values shown in Table 4–23. The
synthesizer control terminals SYNCLK, SYNLE0, SYNLE1, SYNLE2, and SYNDTA are high after reset, and
the synthesizer interface circuit is in the stable idle state with no SYNCLK outputs.
Table 4–23. Power-On Reset Register Initialization
REGISTER NAME
BIT 9 8
7
6
5
4
3
2
1
0
DIntCtrl
0
1
0
0
0
r
r
r
r
r
DStatCtrl
0
0
0
0
0
0
0
0
0
0
MIntCtrl
0
0
0
0
0
0
0
r
MStatCtrl
ext ext
1
1
0
0
0
0
MCClock
0
0
0
0
0
0
NOTE 6: r= reserved; ext= bit value from external terminal
4–28