SLAS191A Datasheet, PDF (53/86 Pages) Texas Instruments – Starter Kit Evaluation Kit Manual

The address of the two breakpoints should not be identical. Only two breakpoints are supported, a third
breakpoint cannot be set. In order to set another breakpoint, one breakpoint has to be cleared first with the
c command. Figure 2–17 shows the breakpoint after entry.
To set a breakpoint type s
Enter the location of the breakpoint: 24e <ENTER>
>init
MSP–STK430A320
>Set Bkpt 0000 0000 24e
>Set Bkpt 024e 0000
Press <ESC> here
Figure 2–17. Set a Breakpoint Command
2–17