SLAS191A Datasheet, PDF (40/86 Pages) Texas Instruments – Starter Kit Evaluation Kit Manual

i The i command, shown in Figure 2–4, initializes the entire monitor program. This command performs
a software reset of the STK/EVK, but is only possible if the monitor is still running. If the contents of
memory location 3DEh are AA55h, the i command will start the user application. Turn off the hardware
supply voltage to return control to the monitor. This clears the bit-pattern AA55h.
Enter i at the command prompt
>init
MSP–STK430A320
Figure 2–4. Initializing the Terminal Program Command
2–4