SLAS191A Datasheet, PDF (32/86 Pages) Texas Instruments – Starter Kit Evaluation Kit Manual

VPP -Input
Apply If
programming via serial
port
VPP fuse F250 mA
Connects to programming
adapter MSP-PRG430x
(EVK only)
Jumper for programming the EPROM
of an EVK with the Monitor
Figure 1–22. Programming Voltage and Jumper Location
To load a program into the MSP430 EPROM/ROM using the HyperTerminal, the following points must be
considered:
• The Monitor code must already be programmed into the EPROM/ROM (only the EVK is supplied
with the code for the monitor program mon_x.txt).
• The STK/EVK 9-pin D-SUB-connector must be connected to the serial interface (the default is
COM2) of the PC.
• The supply voltages of the STK/EVK must be applied by connecting the STK/EVK to the serial
interface of the PC and by connecting the programming supply voltage.
NOTE: Programming the EVK using the Serial Port
Attach a jumper between PIN 13 and PIN 14 on the Programming Adapter connector (see
Hardware Installation in Chapter 9).
If the assembled file gs_stk5.asm is downloaded, the program routines for the LCD, and the interrupt routine
of the previous example will be written into the EPROM/ROM (see sections in the code).
1–26