SLAS191A Datasheet, PDF (44/86 Pages) Texas Instruments – Starter Kit Evaluation Kit Manual

Figure 2–8 shows the procedure for changing data in a register. Write new data into register r[i] by pressing
<ENTER> and the program displays the next register.
Type r5 <ENTER> at the command prompt
Type the new desired register contents and press <ENTER>
>init
MSP–STK430A320
>r5
reg 0005 : 0010 ffff
reg 0006 0069
>r5
reg 0005 : 0010 ffff_
Type r5 again to view the new content of the register
If it is not desired to modify additional registers press <ESC>
Figure 2–8. Modify One Register
2–8