OMAPL137CZKBT3 Datasheet, PDF (43/222 Pages) Texas Instruments – OMAP-L137 Low-Power Applications Processor

www.ti.com
OMAP-L137
SPRS563G – SEPTEMBER 2008 – REVISED JUNE 2014
3.7.17 Ethernet Media Access Controller (EMAC)
Table 3-21. Ethernet Media Access Controller (EMAC) Terminal Functions
SIGNAL NAME
PIN
NO
ZKB
TYPE ⁽¹⁾
PULL ⁽²⁾
MUXED
DESCRIPTION
RMII
AHCLKR0/RMII_MHZ_50_CLK/GP2[14]/BOOT[11]
A4
I/O
IPD McASP0, GPIO, BOOT
EMAC 50-MHz
clock input or output
AXR0[6]/RMII_RXER/ACLKR2/GP3[6]
D7
I
IPD
EMAC RMII receiver
error
AXR0[5]/RMII_RXD[1]/AFSX2/GP3[5]
AXR0[4]/RMII_RXD[0]/AXR2[1]/GP3[4]
C7
I
IPD
B7
I
IPD
EMAC RMII receive
data
AXR0[3]/RMII_CRS_DV/AXR2[2]/GP3[3]
A7
I
IPD McASP0, McASP2, GPIO
EMAC RMII carrier
sense data valid
AXR0[2]/RMII_TXEN/AXR2[3]/GP3[2]
D8
O
IPD
EMAC RMII transmit
enable
AXR0[1]/RMII_TXD[1]/ACLKX2/GP3[1]
AXR0[0]/RMII_TXD[0]/AFSR2/GP3[0]
C8
O
IPD
B8
O
IPD
EMAC RMII trasmit
data
MDIO
AXR0[8]/MDIO_D/GP3[8]
AXR0[7]/MDIO_CLK/GP3[7]
B6
I/O
A6
O
IPU
McASP0, GPIO
IPD
MDIO serial data
MDIO clock
(1) I = Input, O = Output, I/O = Bidirectional, Z = High impedance, PWR = Supply voltage, GND = Ground, A = Analog signal.
Note: The pin type shown refers to the input, output or high-impedance state of the pin function when configured as the the signal name
highlighted in bold. All multiplexed signals may enter a high-impedance state when the configured function is input-only or the configured
function supports high-Z operation. All GPIO signals can be used as input or output. For multiplexed pins where functions have different
types (ie., input versus output), the table reflects the pin function direction for that particular peripheral.
(2) IPD = Internal Pulldown resistor, IPU = Internal Pullup resistor
Copyright © 2008–2014, Texas Instruments Incorporated
Submit Documentation Feedback
Product Folder Links: OMAP-L137
Device Overview
43