English
Language : 

RI-CTL-MB2B-30 Datasheet, PDF (26/40 Pages) Texas Instruments – Series 2000 Reader System
www.ti.com
Synchronization Interface
To allow the synchronization of up to 32 readers, the Series 2000 firmware provides six types of
synchronization (or No Sync if you are not going to use synchronization)
• Wireless synchronization
• Wireless
• Wired
• Combined wireless/wired
• Master/slave (with or without acknowledgement)
• Triggered
This specification covers the way the readers have to be connected for the wired, combined
wireless/wired, Master/Slave and triggered synchronization.
When you have completed the hardware synchronization, you must run the configuration utility
(S2_Util.exe) as described in Section 2.4, in order to tell the system which synchronization method you
have installed, and then set the dipswitch S1.1 to the ON position.
2.8.2 Wired and Combined Wireless/Wired Synchronization
Figure 2-15 shows the way in which the Control Module must be connected for a wired and combined
wireless and wired synchronization. The Control Module also has to be software configured to the chosen
synchronization method. Table 2-13 explains the setting of jumpers 12, 13 and 14 (JP12, JP13 and JP14).
Figure 2-15. Wired and/or Combined Wireless/Wired Synchronization
Table 2-13. Wired and Combined Wireless/Wired Synchronization
Jumper 12 (JP12)
Jumper 13 (JP13)
Jumper 14 (JP14)
UNIT(1)
Closed
Closed (1)
Closed
UNIT(2) to UNIT(n-1)
Open
Open
Open
UNIT(n)
Closed
Closed (1)
Closed
(1) If the distance between Unit(1) and Unit(n) is less than approximately 400 m, Jumper 13 (JP13) can be left out.
2.8.3 Master/ Slave Synchronization without Acknowledgement; Triggered
Synchronization without Acknowledgement
Figure 2-16 shows the way that the Series 2000 readers have to be connected for Master/ Slave
synchronization or Triggered synchronization, both without acknowledgement. The individual SW
configuration (Master or Slave) is shown in Table 2-14 and Table 2-15. The tables also explain the setting
of jumpers 12, 13 and 14 (JP12, JP13 and JP14).
26
Installation
SCBU044 (11-09-21-077) – January 2008
Submit Documentation Feedback