RI-CTL-MB2B-30 Datasheet, PDF (14/40 Pages) Texas Instruments – Series 2000 Reader System

General
www.ti.com
2.1 General
CAUTION
Handle your S2000 Control Module only according to ESD handling
requirements!
Since the human body can be charged up to thousands of volts (electrostatic
charge) you should not touch any part or connector of the Control Module
without taking appropriate precautions.
2.2 Mechanical Installation
Mount the RFM on top of the Control Module using four M3 hexagon spacing bolts so that the connector
for the supply voltages and interface signal lines from the Control Module (ST4) with its counterpart on the
RFM. Both High Performance RFMs require 2-mm spacers and 10-mm screws.
2.3 Electrical Installation
The Series 2000 Control Module has 10 plug and screw connectors which provide all connections
necessary for supply and control (see Figure 2-1). The connections are given in Section 2.3.1.
Figure 2-1. Bottom View of Series 2000 Control Board
Note: ST4 is the RFM connector and is accessible from the top.
14
Installation
SCBU044 (11-09-21-077) – January 2008
Submit Documentation Feedback