LM3S818 Datasheet, PDF (230/572 Pages) Bookham, Inc. – Microcontroller

General-Purpose Input/Outputs (GPIOs)
7 General-Purpose Input/Outputs (GPIOs)
The GPIO module is composed of five physical GPIO blocks, each corresponding to an individual
GPIO port (Port A, Port B, Port C, Port D, Port E). The GPIO module supports 0-30 programmable
input/output pins, depending on the peripherals being used.
The GPIO module has the following features:
■ 0-30 GPIOs, depending on configuration
■ 5-V-tolerant in input configuration
■ Fast toggle capable of a change every two clock cycles
■ Programmable control for GPIO interrupts
– Interrupt generation masking
– Edge-triggered on rising, falling, or both
– Level-sensitive on High or Low values
■ Bit masking in both read and write operations through address lines
■ Can initiate an ADC sample sequence
■ Pins configured as digital inputs are Schmitt-triggered.
■ Programmable control for GPIO pad configuration
– Weak pull-up or pull-down resistors
– 2-mA, 4-mA, and 8-mA pad drive for digital communication
– Slew rate control for the 8-mA drive
– Open drain enables
– Digital input enables
230
July 14, 2014
Texas Instruments-Production Data