|
LM3S308 Datasheet, PDF (20/537 Pages) Texas Instruments – ARM and Thumb are registered trademarks and Cortex is a trademark | |||
|
◁ |
Revision History
Table 1. Revision History (continued)
Date
September 2010
Revision
7783
Description
â Reorganized ARM Cortex-M3 Processor Core, Memory Map and Interrupts chapters, creating two
new chapters, The Cortex-M3 Processor and Cortex-M3 Peripherals. Much additional content was
added, including all the Cortex-M3 registers.
â Changed register names to be consistent with StellarisWare names: the Cortex-M3 Interrupt Control
and Status (ICSR) register to the Interrupt Control and State (INTCTRL) register, and the
Cortex-M3 Interrupt Set Enable (SETNA) register to the Interrupt 0-31 Set Enable (EN0) register.
â Added clarification of instruction execution during Flash operations.
â Modified Figure 7-1 on page 227 to clarify operation of the GPIO inputs when used as an alternate
function.
â Added caution not to apply a Low value to PB7 when debugging; a Low value on the pin causes
the JTAG controller to be reset, resulting in a loss of JTAG communication.
â In General-Purpose Timers chapter, clarified operation of the 32-bit RTC mode.
â Added missing table "Connections for Unused Signals" (Table 16-5 on page 493).
â In Electrical Characteristics chapter:
â Added ILKG parameter (GPIO input leakage current) to Table 18-4 on page 496.
â Corrected values for tCLKRF parameter (SSIClk rise/fall time) in Table 18-16 on page 504.
â Added dimensions for Tray and Tape and Reel shipping mediums.
June 2010
April 2010
7393
7004
â Corrected base address for SRAM in architectural overview chapter.
â Clarified system clock operation, adding content to âClock Controlâ on page 155.
â In Signal Tables chapter, added table "Connections for Unused Signals."
â In "Reset Characteristics" table, corrected value for supply voltage (VDD) rise time.
â Additional minor data sheet clarifications and corrections.
â Added caution note to the I2C Master Timer Period (I2CMTPR) register description and changed
field width to 7 bits.
â Added note about RST signal routing.
â Clarified the function of the TnSTALL bit in the GPTMCTL register.
â Additional minor data sheet clarifications and corrections.
20
June 18, 2012
Texas Instruments-Production Data
|
▷ |