DRV8850_16 Datasheet, PDF (18/30 Pages) Texas Instruments – Low-Voltage H-Bridge IC with LDO Voltage Regulator

DRV8850
SLVSCC0B – NOVEMBER 2013 – REVISED DECEMBER 2015
www.ti.com
7.4 Device Functional Modes
The DRV8850 internal logic and charge pump are operating unless nSLEEP is pulled low. The LDO regulator
can be active independent of the nSLEEP pin. This independence allows a microcontroller or other device to be
powered by the LDO regulator while retaining the ability to put the DRV8850 into sleep mode.
If LDOEN and nSLEEP are both brought logic low the device will minimize current consumption in sleep mode.
While the LDO regulator remains active n sleep mode, a quiescent current (typically 50 µA plus current through
the external feedback resistors) is drawn from the supply.
Each FET inside the device is controlled by a corresponding input pin on the DRV8850. The condition where
both HS and LS FETs are turned on at the same time is not allowed. During this input condition both the HS and
LS FETs turn off.
18
Submit Documentation Feedback
Product Folder Links: DRV8850
Copyright © 2013–2015, Texas Instruments Incorporated