|
TLC320AD75C Datasheet, PDF (21/43 Pages) Texas Instruments – 20-Bit Sigma-Delta Stereo ADA Circuit | |||
|
◁ |
2.15 Sigma-Delta DAC Modulator
The DAC uses a third-order modulator with 32 times oversampling. The DAC provides high-resolution,
low-noise performance using a 15-value PWM output as shown in Figure 2â11.
APB(max)â
Quantization Noise Power With Noise Shaping
Audio
Signal
Noise Excluded by
Low-Pass Filter
Quantization Noise Power Without Noise Shaping
0
0
fBâ¡
0.1
0.2
0.3
0.4
Normalized Analog-Output Frequency (fO/fs§)
0.5
â APB(max) is the passband maximum amplitude.
â¡
§
fB
fO
is
is
the
the
highest frequency of interest within the baseband.
output frequency at the external low-pass filter output.
Figure 2â11. Oversampling Noise Power With and Without Noise Shaping
2.16 DAC Interpolation Filter
The interpolation filter used prior to the DAC increases the digital-data rate from the LRCKD speed to the
oversampled rate by interpolating with a ratio of 1:32. The oversampling modulator receives the output of
this filter with de-emphasis as an option.
2.17 DAC PWM Output (L2âL1 and R2âR1)
The L2 â L1 and the R2 â R1 output pairs are PWM signals with the L2 â L1 differential pulse duration
determining the left-channel analog voltage and the R2 â R1 differential pulse duration determining the
right-channel analog voltage.
Each DAC left and right output consists of 15 levels of PWM and provides a differential signal as the input
to two external differential amplifiers configured as a low-pass filter to produce the left and right audio
outputs.
2â9
|
▷ |