AM1806_101 Datasheet, PDF (110/243 Pages) Texas Instruments – ARM Microprocessor

AM1806
SPRS658B – FEBRUARY 2010 – REVISED MAY 2010
www.ti.com
6.11.3.8 Net Classes
Table 6-31 lists the clock net classes for the DDR2/mDDR interface. Table 6-32 lists the signal net
classes, and associated clock net classes, for the signals in the DDR2/mDDR interface. These net classes
are used for the termination and routing rules that follow.
Clock Net Class
CK
DQS0
DQS1
Table 6-31. Clock Net Class Definitions
Pin Names
DDR_CLKP / DDR_CLKN
DDR_DQS[0]
DDR_DQS[1]
Clock Net Class
ADDR_CTRL
D0
D1
DQGATE
Table 6-32. Signal Net Class Definitions
Associated Clock Net Class Pin Names
CK
DDR_BA[2:0], DDR_A[13:0], DDR_CS, DDR_CAS, DDR_RAS, DDR_WE,
DDR_CKE
DQS0
DDR_D[7:0], DDR_DQM0
DQS1
DDR_D[15:8], DDR_DQM1
CK, DQS0, DQS1
DDR_DQGATE0, DDR_DQGATE1
6.11.3.9 DDR2/mDDR Signal Termination
No terminations of any kind are required in order to meet signal integrity and overshoot requirements.
Serial terminators are permitted, if desired, to reduce EMI risk; however, serial terminations are the only
type permitted. Table 6-33 shows the specifications for the series terminators.
Table 6-33. DDR2/mDDR Signal Terminations
No. Parameter
1 CK Net Class
2 ADDR_CTRL Net Class
3 Data Byte Net Classes (DQS[0], DQS[1], D0, D1)
4 DQGATE Net Class (DQGATE)
Min Typ Max Unit
Notes
0
10 Ω See Note ⁽¹⁾
0
22
Zo
Ω See Notes ⁽¹⁾, ⁽²⁾, ⁽³⁾
0
22
Zo
Ω See Notes ⁽¹⁾, ⁽²⁾, ⁽³⁾, ⁽⁴⁾
0
10
Zo
Ω See Notes ⁽¹⁾, ⁽²⁾, ⁽³⁾
(1) Only series termination is permitted, parallel or SST specifically disallowed.
(2) Terminator values larger than typical only recommended to address EMI issues.
(3) Termination value should be uniform across net class.
(4) When no termination is used on data lines (0 Ω), the DDR2/mDDR devices must be programmed to operate in 60% strength mode.
110 Peripheral Information and Electrical Specifications
Submit Documentation Feedback
Product Folder Link(s): AM1806
Copyright © 2010, Texas Instruments Incorporated