English
Language : 

GS2962 Datasheet, PDF (52/82 Pages) Gennum Corporation – Integrated Narrow-Bandwidth PLL
Table 4-6: SMPTE 352M Packet Data
Register Name
Bit
Name
VIDEO_FORMAT_352_IN_WORD_2
VIDEO_FORMAT_352_IN_WORD_1
VIDEO_FORMAT_352_IN_WORD_4
VIDEO_FORMAT_352_IN_WORD_3
15-8
7-0
15-8
7-0
15-8
7-0
15-8
7-0
VIDEO_FORMAT_IN
_DS1_4
(Byte 4)
VIDEO_FORMAT_IN
_DS1_3
(Byte 3)
VIDEO_FORMAT_IN
_DS1_2
(Byte 2)
VIDEO_FORMAT_IN
_DS1_1
(Byte 1)
VIDEO_FORMAT_IN
_DS2_4
(Byte 4)
VIDEO_FORMAT_IN
_DS2_3
(Byte 3)
VIDEO_FORMAT_IN
_DS2_2
(Byte 2)
VIDEO_FORMAT_IN
_DS2_1
(Byte 1)
Description
Data will be available in this register
when Video Payload Identification
Packets are detected in the data stream.
Data will be available in this register
when Video Payload Identification
Packets are detected in the data stream.
Data will be available in this register
when Video Payload Identification
Packets are detected in the data stream.
Data will be available in this register
when Video Payload Identification
Packets are detected in the data stream.
Data will be available in this register
when Video Payload Identification
Packets are detected in the data stream.
Data will be available in this register
when Video Payload Identification
Packets are detected in the data stream.
Data will be available in this register
when Video Payload Identification
Packets are detected in the data stream.
Data will be available in this register
when Video Payload Identification
Packets are detected in the data stream.
R/W Default
R
0
R
0
R
0
R
0
R
0
R
0
R
0
R
0
4.8.2.2 Level B Signals:
For Level B inputs, the GS2962 does not extract the SMPTE 352M packets from the
parallel input. The only source of SMPTE 352M packets in Level B mode, to be used for
format detection and for embedding in the output data streams, is from the user
programmed registers in the host interface.
4.8.3 ANC Data Blanking
The GS2962 can blank the video input data during the H and V blanking periods. This
function will be enabled by setting the ANC_BLANK pin LOW.
This function is only available when the device is operating in SMPTE mode
(SMPTE_BYPASS = HIGH).
In this mode, input video data in the horizontal and vertical blanking periods will be
replaced by SMPTE compliant blanking values.
The blanking function will operate only on the video input signal and will remove all
ancillary data already embedded in the input video stream.
GS2962 3G/HD/SD-SDI Serializer with Complete
SMPTE Video Support
Data Sheet
48005 - 7
October 2010
52 of 82