M37221M6_03 Datasheet, PDF (54/62 Pages) Renesas Technology Corp – SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER for VOLTAGE SYNTHESIZER with ON-SCREEN DISPLAY CONTROLLER

MITSUBISHI MICROCOMPUTERS
M37221M6-XXXSP
SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER for VOLTAGE SYNTHESIZER
with ON-SCREEN DISPLAY CONTROLLER
ELECTRIC CHARACTERISTICS (VCC = 5 V ± 10 %, VSS = 0 V, f(XIN) = 8 MHz, Ta = –10 °C to 70 °C, unless otherwise noted)
Symbol
Parameter
ICC
Power source current System operation
Test conditions
Min.
CRT OFF
VCC = 5.5 V,
f(XIN) = 8 MHz CRT ON
Limits
Typ.
20
30
Unit
Max.
40
mA
60
Stop mode
VCC = 5.5 V, f(XIN) = 0
VOH
“H” output voltage R, G, B, OUT1, D-A, P10–P17, VCC = 4.5 V
2.4
P20–P27, P30, P31
IOH = –0.5 mA
VOL
“L” output voltage R, G, B, OUT1, D-A, P00–P07, VCC = 4.5 V
P10, P15–P17, P20–P23,
IOL = 0.5 mA
P30–P32
300
µA
V
0.4
V
“L” output voltage P11–P14
VCC = 4.5 V IOL = 3 mA
0.4
IOL = 6 mA
0.6
“L” output voltage P24–P27
VCC = 4.5 V
3.0
IOL = 10.0 mA
VT+–VT– Hysteresis
RESET
VCC = 5.0 V
0.5
0.7
V
IIZH
IIZL
IOZH
Hysteresis (Note)
HSYNC, VSYNC, TIM2, TIM3, VCC = 5.0 V
INT1, INT2, INT3, SCL1,
SCL2, SDA1, SDA2, SIN, SCLK
“H” input leak current RESET, P00–P07, P10–P17,
P20–P27, P30–P34, HSYNC,
VSYNC
VCC = 5.5 V
VI = 5.5 V
“L” input leak current RESET, P00–P07, P10–P17,
P20–P27, P30–P34, HSYNC,
VSYNC
VCC = 5.5 V
VI = 0 V
“H” output leak current P00–P05
VCC = 5.5 V
VO = 12 V
0.5
1.3
5
µA
5
µA
10
µA
RBS
I²C-BUS·BUS switch connection resistor
VCC = 4.5 V
(between SCL1 and SCL2, SDA1 and SDA2)
130
Ω
Note: P06, P07, P15, P23, P24 have the hysteresis when these pins are used as interrupt input pins or timer input pins. P20–P22 have the
hysteresis when these pins are used as serial I/O pins. P11–P14 have the hysteresis when these pins are used as multi-master I²C-BUS
interface pins.
53