AN91184 Datasheet, PDF (18/36 Pages) Ramtron International Corporation – Designing BLE Applications

PSoC® 4 BLE – Designing BLE Applications
16. Place two Analog Pin Components, and configure them per Figure 20 and Figure 21.
Note: These pins are configured as both analog pins and digital outputs. The digital output will allow us to drive
either pin to either Vdd or Vss from the firmware.
Figure 20. Analog Pin Configuration – V_HIGH
Figure 21. Analog Pin Configuration – V_LOW
17. Place an Analog Pin Component and name it as “V_THERM.” Enable the External terminal.
www.cypress.com
Document No. 001-91184 Rev. *B
18