AN91184 Datasheet, PDF (12/36 Pages) Ramtron International Corporation – Designing BLE Applications

PSoC® 4 BLE – Designing BLE Applications
Service
Device
Information
Characteristic
Descriptor
Manufacturer
Name String
N/A
Model Number
String
N/A
Serial Number
String
N/A
Hardware
Revision String
N/A
Firmware
Revision String
N/A
Software Revision
String
N/A
Fields
Manufacturer Name
Model Number
Serial Number
Hardware Revision
Firmware Revision
Software Revision
Value
Cypress Semiconductor
1.0
**
CY8CKIT-042-BLE
**
PSoC Creator 3.2
Remarks
User-defined
User-defined
User-defined
User-defined
User-defined
User-defined
Keep the remaining settings at their default values.
6. Configure the Bluetooth Device Address (BD_ADDR), the Device name, and the Appearance under General
settings of the GAP Settings tab, per Table 2.
Table 2. General Settings
Name
Public
address
Device
name
Appearance
Value
Check Silicon
Generated
Address
MyThermometer
Generic
Thermometer
Remarks
Use your Company ID and Company-assigned values as the address. If you do not have
these details, add the desired address in the field.
User-defined
The possible values are defined by the Bluetooth SIG. The BLE Component provides an
option to select one of the possible values.
Figure
Figure 11
Figure 11
Figure 11
Note: Public address refers to the unique 48-bit BD_ADDR that is used to identify the device. It is divided into
two parts: Company ID (24 bits) and Company assigned (24 bits). By default, the public address is loaded with
the Company ID of Cypress Semiconductor. You should use your 24-bit Company ID assigned by IEEE.
www.cypress.com
Document No. 001-91184 Rev. *B
12