English
Language : 

HYS72T64400HFD Datasheet, PDF (3/42 Pages) Qimonda AG – 240-Pin Fully-Buffered DDR2 SDRAM Modules
Internet Data Sheet
1
Overview
HYS72T[64/128/256]4[00/20]HFD–[3S/3.7]–A
This chapter describes the main characteristics of the 240-Pin Fully-Buffered DDR2 SDRAM Modules product family.
1.1
Features
• 240-pin Fully-Buffered ECC Dual-In-Line
DDR2 SDRAM Module for PC, Workstation and Server
main memory applications.
• Module organisation one rank 64M ×72,
one rank 128M ×72, two ranks 128M ×72,
two ranks 256M ×72
• JEDEC Standard Double Data Rate 2
Synchronous DRAMs (DDR2 SDRAMs) with 1.8 V
(± 0.1 V) power supply.
• Built with 512Mb DDR2 SDRAMs in 60-ball FBGA
Chipsize Packages.
• Re-drive and re-sync of all address, command, clock and
data signals using AMB (Advanced Memory Buffer).
• High-Speed Differential Point-to-Point Link Interface at
1.5 V (Jedec standard pending).
• Host Interface and AMB component industry standard
compliant.
• Supports SMBus protocol interface for access to the AMB
configuration registers.
• Detects errors on the channel and reports them to the host
memory controller.
• Automatic DDR2 DRAM Bus Calibration.
• Automatic Channel Calibration.
• Full Host Control of the DDR2 DRAMs.
• Over-Temperature Detection and Alert.
• Hot Add-on and Hot Remove Capability.
• MBIST and IBIST Test Functions.
• Transparent Mode for DRAM Test Support.
• Low profile: 133.35mm × 30.35 mm
• 240 Pin gold plated card connector with 1.00mm contact
centers (JEDEC standard pending).
• Based on JEDEC standard reference card designs (Jedec
standard pending).
• SPD (Serial Presence Detect) with 256 Byte serial
E2PROM.Performance:
• RoHS Compliant Products1)
Product Type Speed Code
Speed Grade
max. Clock Frequency
min. RAS-CAS-Delay
min. Row Precharge Time
min. Row Active Time
min. Row Cycle Time
@CL5
@CL4
@CL3
TABLE 1
Performance for DDR2–667 and DDR2–533
–3S
–3.7
Unit
PC2–5300 5–5–5
fCK5 333
fCK4 266
fCK3 200
tRCD 15
tRP
15
tRAS 45
tRC
60
PC2–4200 4–4–4
266
266
200
15
15
45
60
—
MHz
MHz
MHz
ns
ns
ns
ns
1) RoHS Compliant Product: Restriction of the use of certain hazardous substances (RoHS) in electrical and electronic equipment as defined
in the directive 2002/95/EC issued by the European Parliament and of the Council of 27 January 2003. These substances include mercury,
lead, cadmium, hexavalent chromium, polybrominated biphenyls and polybrominated biphenyl ethers.
Rev. 1.2, 2006-11
3
03292006-GUME-ERC3