English
Language : 

HYB25D512800BT Datasheet, PDF (17/38 Pages) Infineon Technologies AG – 512Mbit Double Data Rate SDRAM
Internet Data Sheet
HYB25D512[40/16/80]0B[E/F/C/T](L)
Double-Data-Rate SDRAM
TABLE 10
Truth Table 1a: Commands
Name (Function)
CS RAS CAS WE Address MNE Note
Deselect (NOP)
H X X XX
NOP
1)2)
No Operation (NOP)
L H H HX
NOP
1)2)
Active (Select Bank And Activate Row)
LL
H
H Bank/Row ACT
1)3)
Read (Select Bank And Column, And Start Read Burst)
LH
L
H Bank/Col Read 1)4)
Write (Select Bank And Column, And Start Write Burst)
LH
L
L Bank/Col Write 1)4)
Burst Terminate
L H H LX
BST
1)5)
Precharge (Deactivate Row In Bank Or Banks)
LL
H
L Code
PRE
1)6)
Auto Refresh Or Self Refresh (Enter Self Refresh Mode)
LL
L
HX
AR/SR 1)7)8)
Mode Register Set
LL
L
L Op-Code MRS
1)9)
1) CKE is HIGH for all commands shown except Self Refresh.
VREF must be maintained during Self Refresh operation
2) Deselect and NOP are functionally interchangeable.
3) BA0-BA1 provide bank address and A0-A12 provide row address.
4) BA0, BA1 provide bank address; A0-Ai provide column address (where i = 8 for ×16, i = 9 for ×8 and 9, 11 for ×4);
A10 HIGH enables the Auto Precharge feature (non persistent), A10 LOW disables the Auto Precharge feature.
5) Applies only to read bursts with Auto Precharge disabled; this command is undefined (and should not be used) for read bursts with Auto
Precharge enabled or for write bursts.
6) A10 LOW: BA0, BA1 determine which bank is precharged.
A10 HIGH: all banks are precharged and BA0, BA1 are “Don’t Care”.
7) This command is AUTO REFRESH if CKE is HIGH; Self Refresh if CKE is LOW.
8) Internal refresh counter controls row and bank addressing; all inputs and I/Os are “Don’t Care” except for CKE.
9) BA0, BA1 select either the Base or the Extended Mode Register (BA0 = 0, BA1 = 0 selects Mode Register; BA0 = 1, BA1 = 0 selects
Extended Mode Register; other combinations of BA0-BA1 are reserved; A0-A12 provide the op-code to be written to the selected Mode
Register).
Name (Function)
Write Enable
Write Inhibit
1) Used to mask write data; provided coincident with the corresponding data.
TABLE 11
Truth Table 1b: DM Operation
DM
DQs Note
L
Valid 1)
H
X
1)
Rev. 1.63, 2006-09
17
03062006-PFFJ-YJY2