MN101EFC3 Datasheet, PDF (33/46 Pages) Panasonic Semiconductor – 8-bit Single-chip Microcontroller

MN101EFC3/D3 Series
8-bit Single-chip Microcontroller
PubNo. 216C3-014E
*13 Measured without loading (pull-up and pull-down resistors are not connected.)
To measure the power supply current during operation IDD1, 2, 3, 4, and 5:
1, set the all I/O pins to input mode,
2, set the CPU mode to <NORMAL>,
3, fix the MMOD pin at V_SS level and input pin at V_DD50 level
4, and input the rectangular wave of 10 MHz (8 MHz, 4 MHz), which has amplitude of V_DD50 and V_SS potential, from the OSCI1 pin.
To measure the power supply current during operation IDD6,
1, set the all I/O pins to input mode,
2, set the CPU mode to <SLOW>,
3, and fix the MMOD pin at VSS level and input pin at V_DD50 level.
clock is supplied from the internal low-speed oscillation circuit.
To measure the power supply current during HALT1 IDD7,
1, set the all I/O pins to input mode,
2, set the CPU mode to <HALT1>,
3, and fix the MMOD pin at VSS level and input pin at V_DD50 level.
To measure the power supply current during STOP IDD8,
1, set the CPU mode to <STOP>,
2, and fix the MMOD pin at VSS level and input pin at V_DD50 level
3, and open the OSC1 pin.
*14 When bp2 of the HANDSHAKE register (0x03F06) is set to “1'b1”
*15 When bp2 of the HANDSHAKE register (0x03F06) is set to “1'b0”
*16 When bp3 of the FEWSPD register (0x03FBF) to “1'b1”
Publication date: November 2015