MN101C115 Datasheet, PDF (31/170 Pages) Panasonic Semiconductor – Request for your special attention and precautions in using the technical information and semiconductors described in this book

1-5-3 DC Characteristics
Ta=–40 to +85°C V =2.0 to 5.5V V =0V
DD
SS
Parameter
Symbol
Conditions
Supply current (no load at output)^∗1
Rating
Unit
MIN TYP MAX
1 Supply current
2 during operation
3
I
DD1
I
DD2
I *2
DD3
fosc=20.0MHz,V =5V
DD
fosc=8.39MHz,V =5V
DD
fx =32.768kHz,V =3V
DD
25
60
mA
10
25
100
4
I ^*2 fx =32.768kHz,V =3V
8
DD5
DD
Supply current during HALT mode
Ta=25 @ @
4Y
2
&HY
6I
@
1'
H
@
@
@L
5
V K4 @ YY
5
6
Supply current during STOP mode
7
I *2
DD6
I
DD7
I
DD8
Ta=-40 to 85˚C
V =5V, Ta=25˚C
DD
V =5V, Ta=-40 to 85˚C
DD
18 µA
0
2
0
20
Notes: ^∗1 Measured under conditions of Ta=25°C and no load.
The supply current during operation, I (I ), is measured under the
DD1 DD2
following conditions: After all I/O pins are set to input mode and the oscillation
is set to <NORMAL mode>, the MMOD pin is fixed at V , the input pins are
SS
fixed at V , and a 20MHz (8.39MHz) square wave of amplitude V ,V is input
DD
DD SS
to the OSC1 pin.
The supply current during operation, I , is measured under the following
DD3
conditions: After all I/O pins are set to input mode and the oscillation is set to
<SLOW mode>, the MMOD pin is fixed at V , the input pins are fixed at V ,
SS
DD
and a 32.768kHz square wave of amplitude V ,V is input to the XI pin.
DD SS
The supply current during HALT mode, I (I ), is measured under the
DD5 DD6
following conditions: After all I/O pins are set to input mode and the oscillation
is set to <HALT mode>, the MMOD pin is fixed at V , the input pins are fixed
SS
at V , and an 32.768kHz square wave of amplitude V ,V is input to the XI
DD
DD SS
pin.
The supply current during STOP mode I (I ) is measured under the following
DD7 DD8
conditions: After the oscillation mode is set to <STOP mode>, the MMOD pin is
fixed at V , the input pins are fixed at V , and the OSC1 and XI pins are
SS
DD
unconnected.
*2 _{The items I (I ) and I (I ) are applicable only for 48-pin QFH package.}
DD5 DD6
DD7 DD8
Chapter 1 Overview
Electrical Characteristics 17