MT9P001 Datasheet, PDF (18/48 Pages) ON Semiconductor – CMOS Digital Image Sensor

MT9P001: 1/2.5-Inch 5Mp Digital Image Sensor
Serial Bus Description
Stop Bit
The stop bit is defined as a LOW-to-HIGH transition of the data line while the clock line
is HIGH.
Slave Address
The 8-bit address of a two-wire serial interface device consists of 7 bits of address and 1
bit of direction. A “0” in the LSB (least significant bit) of the address indicates write mode
(0xBA), and a “1” indicates read mode (0xBB).
Data Bit Transfer
One data bit is transferred during each clock pulse. The serial interface clock pulse is
provided by the master. The data must be stable during the HIGH period of the two-wire
serial interface clock—it can only change when the serial clock is LOW. Data is trans-
ferred 8 bits at a time, followed by an acknowledge bit.
Acknowledge Bit
The master generates the acknowledge clock pulse. The transmitter (which is the master
when writing, or the slave when reading) releases the data line, and the receiver indi-
cates an acknowledge bit by pulling the data line LOW during the acknowledge clock
pulse.
No-Acknowledge Bit
The no-acknowledge bit is generated when the data line is not pulled down by the
receiver during the acknowledge clock pulse. A no-acknowledge bit is used to terminate
a read sequence.
MT9P001_DS Rev. L 4/15 EN
18
©Semiconductor Components Industries, LLC,2015.