E3X-DA11-N Datasheet, PDF (24/36 Pages) Omron Electronics LLC – The Ultimate Fiber Amplifier for Maximum Ease of Use and High Performance

E3X-DA-N
Optical Communications
Several Amplifiers can be slid together and used in groups.
Do not, however, slide the Amplifiers or attempt to remove any
of the Amplifiers during operation.
Hysteresis Adjustment
The hysteresis setting can be adjusted using the Mobile
Console. Do not, however, set the hysteresis to a value lower
than the factory setting. Using a setting less than the factory
setting may result in incorrect operation.
Amplifiers with Connectors
● Mounting
Mounting Connectors
(1) Insert the Master or Slave Connector into the Amplifier
until it clicks into place.
The clip can also be removed using the following mechanism,
which is incorporated in the construction of the section
underneath the clip.
(1) Insert the clip to be removed into the slit underneath the
clip on another Amplifier.
(2) Remove the clip by rotating the Amplifier.
Rotate
Insert
(2) Join Amplifiers together as required after all the Master
and Slave Connectors have been inserted.
(3) Attach the stickers (provided as accessories) to the sides
of Master and Slave Connectors that are not connected to
other Connectors.
When using the E3X-DA-N with the Mobile Console, mount
the End Plate in the way shown below.
Sticker
Sticker
Note: Attach the stickers to the sides with grooves.
Removing Connectors
(1) Slide the slave Amplifier(s) for which the Connector is to
be removed away from the rest of the group.
(2) After the Amplifier(s) has been separated, press down on
the lever on the Connector and remove it. (Do not attempt
to remove Connectors without separating them from other
Amplifiers first.)
Press down
Lever
End Plate
Pull Strengths for Connectors (Including Cables)
E3X-CN11, E3X-CN21, E3X-CN22: 30 N max.
E3X-CN12: 12 N max.
Remove
Mounting End Plate (PFP-M)
Depending on how it is mounted, an Amplifier may move
during operation. In this case, use an End Plate.
Before mounting an End Plate, remove the clip from the
master Amplifier using a nipper or similar tool.
Clip
http://www.ia.omron.com/
(c)Copyright OMRON Corporation 2007 All Rights Reserved.
24