E3X-DA-S Datasheet, PDF (17/28 Pages) Omron Electronics LLC – Digital Fiber Sensors

E3X-DA-S
Function
6. Display switch
Setting (display)
Incident level Threshold
% incident level Threshold
PEAK
BOTM
Fixed interval
L-PE
D-BT
Detection status
Description
Used to display the incident light level and the
threshold.
Used to display the incident light level as a percentage of
the threshold and the threshold.
Used to display the peak and bottom levels of incident
light within a set time. (Updated every 2 s.)
Use to display the incident light peak level and no incident
light bottom level. (Refreshed when output turns ON or OFF.)
Analog bar display. The current detection status is
displayed as an analog bar. The bar will lengthen
from the right as ON status is reached.
(ON: Red, OFF: Green)
7. Display orientation
Current incident PEAK
level
Fixed interval
Used to display the current incident light level and the peak
Current incident Peak incident incident light level. Display changes at a fixed interval.
level
level
Incident level Channel (unit number)
Used to display the incident light level and the channel
(unit number).
Normal display:
, Up/down reversed display:
Used to reverse the orientation of the display.
8. ECO Mode
Lit degital display: , Dimmed degital display:
OFF:
,
Used to enable or disable the ECO mode.
9. Output setting
Each channel:
,
Output when the incident light level is between two thresholds:
Self-diagnosis output:
Used to change the output details for channel 2.
,
This setting will be disabled if the detection function is set
to DIFF (i.e., differential operation) and the output will be
used for an alarm output.
10. External input
Through-beam, no-workpiece teaching:
,
Reflective, no-workpiece teaching:
,
Two-point teaching:
, Automatic teaching:
,
Power tuning:
, Zero reset:
,
Light OFF:
, ATC start:
Used to change the functions to be controlled using the
external input.
(Refer to the Instruction Manual provided with the sensor.)
11. External input
memory
Write results to EEPROM: ,
Do not write results to EEPROM:
Used to set writing the results.
(Refer to Instruction Manual provided with the product.)
17