TDA6650ATT Datasheet, PDF (19/54 Pages) NXP Semiconductors – 5 V mixer/oscillator and low noise PLL synthesizer for hybrid terrestrial tuner (digital and analog)

NXP Semiconductors
TDA6650ATT; TDA6651ATT
5 V mixer/oscillator and low noise PLL synthesizer
Table 18. Limiting values …continued
In accordance with the Absolute Maximum Rating System (IEC 60134). Positive currents are
entering the IC and negative currents are going out of the IC; all voltages are referenced to ground
(GND)^[1].
Symbol Parameter
Conditions
Min Max
Unit
V_n
voltage on all other inputs, 4.5 V < V_CC < 5.5 V ^[2] −0.3 V_CC + 0.3 V
outputs and combined
inputs and outputs, except
GNDs
I_BSn
PMOS port output current corresponding port
−20 0
mA
on; open-drain
I_BS(tot)
sum of all PMOS port output open-drain
currents
−50 0
mA
t_sc(max)
maximum short-circuit time each pin to V_CC or
-
10
s
to GND
T_stg
T_amb
T_j
storage temperature
ambient temperature
junction temperature
−40 +150
°C
[3] _−20
T_amb(max)
°C
-
150
°C
[1] Maximum ratings cannot be exceeded, not even momentarily without causing irreversible IC damage.
Maximum ratings cannot be accumulated.
[2] V_CC refers to the operating supply voltage.
[3] The maximum allowed ambient temperature T_amb(max) depends on the assembly conditions of the package
and especially on the design of the printed-circuit board. The application mounting must be done in such a
way that the maximum junction temperature is never exceeded. An estimation of the junction temperature
can be obtained through measurement of the temperature of the top center of the package (T_package). The
temperature difference junction to case (∆T_j-c) is estimated at about 13 °C on the demo board (PCB 827-3).
The junction temperature T_j = T_package + ∆T_j-c.
11. Thermal characteristics
Table 19.
Symbol
R_th(j-a)
Thermal characteristics
Parameter
thermal resistance from
junction to ambient
TDA6650ATT
TDA6651ATT
Conditions
in free air
Typ
[1][2][3]
82
74
Unit
K/W
K/W
[1] Measured in free air as defined by JEDEC standard JESD51-2.
[2] These values are given for information only. The thermal resistance depends strongly on the nature and
design of the printed-circuit board used in the application. The thermal resistance given corresponds to the
value that can be measured on a multilayer printed-circuit board (4 layers) as defined by JEDEC standard.
[3] The junction temperature influences strongly the reliability of an IC. The printed-circuit board used in the
application contributes in a large part to the overall thermal characteristic. It must therefore be insured that
the junction temperature of the IC never exceeds T _j(max) = 150 °C at the maximum ambient temperature.
TDA6650ATT_6651ATT_2
Product data sheet
Rev. 02 — 2 February 2007
© NXP B.V. 2007. All rights reserved.
19 of 54