N25Q032A13ESE40F Datasheet, PDF(21/82 Page) Micron Technology

English

English German Russian Spanish Italian Polish Chinese Japanese Korean French Portuguese	Language :

N25Q032A13ESE40F Datasheet, PDF (21/82 Pages) Micron Technology – SPI-compatible serial bus interface

◁

32Mb, 3V, Multiple I/O Serial Flash Memory

Nonvolatile and Volatile Registers

Nonvolatile and Volatile Configuration Registers

Table 10: Nonvolatile Configuration Register Bit Definitions

Note 1 applies to entire table

Bit Name

Settings

Description

Notes

15:12 Number of

dummy clock

cycles

0000 (identical to 1111)

0001

0010

1101

1110

1111

Sets the number of dummy clock cycles subse-

2, 3

quent to all FAST READ commands.

The default setting targets the maximum al-

lowed frequency and guarantees backward com-

patibility.

11:9 XIP mode at 000 = XIP: Fast Read

power-on re- 001 = XIP: Dual Output Fast Read

set

010 = XIP: Dual I/O Fast Read

011 = XIP: Quad Output Fast Read

100 = XIP: Quad I/O Fast Read

101 = Reserved

110 = Reserved

111 = Disabled (Default)

Enables the device to operate in the selected XIP

mode immediately after power-on reset.

8:6 Output driver 000 = Reserved

strength

001 = 90 Ohms

010 = 60 Ohms

011 = 45 Ohms

100 = Reserved

101 = 20 Ohms

110 = 15 Ohms

111 = 30 (Default)

Optimizes impedance at VCC/2 output voltage.

5 Reserved

"Don't Care."

4 Reset/hold

0 = Disabled

1 = Enabled (Default)

Enables or disables hold or reset.

(Available on dedicated part numbers.)

3 Quad I/O pro- 0 = Enabled

Enables or disables quad I/O protocol.

tocol

1 = Disabled (Default, Extended SPI prot-

cocol)

2 Dual I/O pro- 0 = Enabled

Enables or disables dual I/O protocol.

tocol

1 = Disabled (Default, Extended SPI pro-

tocol)

1:0 Reserved

"Don't Care."

1:0 Reserved

"Don't Care."

1 Reserved

"Don't Care."

0 Lock

0 = Disabled

nonvolatile 1 = Enabled (Default)

configuration

When this bit is set to 0, the nonvolatile configu-

ration register becomes permanently write pro-

tected and any WRITE NONVOLATILE CONFIGU-

RATION REGISTER command is ignored.

Notes: 1. Settings determine device memory configuration after power-on. The device ships from

the factory with all bits erased to 1 (FFFFh). The register is read from or written to by

PDF: 09005aef84566622

n25q_32mb_3v_65nm.pdf - Rev. G 9/12 EN

Micron Technology, Inc. reserves the right to change products or specifications without notice.

▷