PIC16F716-I-P Datasheet, PDF (9/136 Pages) Microchip Technology – 8-bit Flash-based Microcontroller with A/D Converter and Enhanced Capture/Compare/PWM

2.0 MEMORY ORGANIZATION
There are two memory blocks in the PIC16F716
device. Each block (program memory and data
memory) has its own bus so that concurrent access
can occur.
2.1 Program Memory Organization
The PIC16F716 has a 13-bit program counter capable
of addressing an 8K x 14 program memory space. The
PIC16F716 has 2K x 14 words of program memory.
Accessing a location above the physically implemented
address will cause a wrap-around.
The Reset vector is at 0000h and the interrupt vector is
at 0004h.
FIGURE 2-1:
PROGRAM MEMORY MAP
AND STACK OF
PIC16F716
PC<12:0>
CALL, RETURN
RETFIE, RETLW
13
Stack Level 1
Stack Level 8
Reset Vector
0000h
PIC16F716
2.2 Data Memory Organization
The data memory is partitioned into multiple banks
which contain the General Purpose Registers (GPR)
and the Special Function Registers (SFR). Bits RP1
and RP0 of the STATUS register are the bank select
bits.
RP<1:0>⁽¹⁾
(Status<6:5>)
Bank
Note 1:
2:
00
0
01
1
10
2⁽²⁾
11
3⁽²⁾
Maintain Status bit 6 clear to ensure
upward compatibility with future products.
Not implemented
Each bank extends up to 7Fh (128 bytes). The lower
locations of each bank are reserved for the Special
Function Registers. Above the Special Function
Registers are General Purpose Registers,
implemented as static RAM. All implemented banks
contain Special Function Registers. The upper 16
bytes of GPR space and some “high use” Special
Function Registers in Bank 0 are mirrored in Bank 1 for
code reduction and quicker access.
Interrupt Vector
On-chip Program
Memory
0004h
0005h
07FFh
0800h
1FFFh
© 2007 Microchip Technology Inc.
DS41206B-page 7