PIC16F716-I-P Datasheet, PDF (54/136 Pages) Microchip Technology – 8-bit Flash-based Microcontroller with A/D Converter and Enhanced Capture/Compare/PWM

PIC16F716
8.3 PWM Mode
The PWM mode generates a Pulse-Width Modulated
signal on the CCP1 pin. The duty cycle, period and
resolution are determined by the following registers:
• PR2
• T2CON
• CCPR1L
• CCP1CON
In Pulse-Width Modulation (PWM) mode, the CCP
module produces up to a 10-bit resolution PWM output
on the CCP1 pin. Since the CCP1 pin is multiplexed
with the PORT data latch, the TRIS for that pin must be
cleared to enable the CCP1 pin output driver.
Note: Clearing the CCP1CON register will
relinquish CCP1 control of the CCP1 pin.
Figure 8-3 shows a simplified block diagram of PWM
operation.
Figure 8-4 shows a typical waveform of the PWM
signal.
For a step-by-step procedure on how to set up the CCP
module for PWM operation, see Section 8.3.7 “Setup
for PWM Operation”.
FIGURE 8-3:
SIMPLIFIED PWM BLOCK
DIAGRAM
Duty Cycle Registers
CCPR1L
CCP1CON<5:4>
The PWM output (Figure 8-4) has a time base
(period) and a time that the output stays high (duty
cycle).
FIGURE 8-4:
Period
CCP PWM OUTPUT
Pulse Width
TMR2 = 0
TMR2 = PR2
TMR2 = CCPR1L:CCP1CON<5:4>
CCPR1H⁽²⁾ (Slave)
Comparator
RQ
CCP1
TMR2
(1)
S
TRIS
Comparator
PR2
Clear Timer2,
toggle CCP1 pin and
latch duty cycle
Note 1:
2:
The 8-bit timer TMR2 register is concatenated
with the 2-bit internal system clock (FOSC), or
2 bits of the prescaler, to create the 10-bit time
base.
In PWM mode, CCPR1H is a read-only register.
DS41206B-page 52
© 2007 Microchip Technology Inc.