PIC16F628-20P Datasheet, PDF (65/170 Pages) Microchip Technology – FLASH-Based 8-Bit CMOS Microcontroller

PIC16F62X
11.2.2 TIMER1 MODE SELECTION
Timer1 must be running in Timer mode or Synchro-
nized Counter mode if the CCP module is using the
compare feature. In Asynchronous Counter mode, the
compare operation may not work.
11.2.3 SOFTWARE INTERRUPT MODE
When generate software interrupt is chosen, the CCP1
pin is not affected. Only a CCP interrupt is generated (if
enabled).
11.2.4 SPECIAL EVENT TRIGGER
In this mode, an internal hardware trigger is generated
which may be used to initiate an action.
The special event trigger output of CCP1 resets the
TMR1 register pair. This allows the CCPR1 register to
effectively be a 16-bit programmable period register for
Timer1.
TABLE 11-3: REGISTERS ASSOCIATED WITH CAPTURE, COMPARE, AND TIMER1
Address Name Bit 7 Bit 6 Bit 5
Bit 4
Bit 3
Bit 2
Bit 1
Bit 0
Value on
POR
Value on
all other
RESETS
0Bh/8Bh/ INTCON
10Bh/
18Bh
GIE PEIE T0IE
INTE
RBIE
T0IF
INTF
RBIF ^{0000 000x 0000 000u}
0Ch
PIR1
EEIF CMIF RCIF
TXIF
—
CCP1IF TMR2IF TMR1IF ^{0000 -000 0000 -000}
8Ch
PIE1
EEIE CMIF RCIE
TXIE
—
CCP1IE TMR2IE TMR1IE ^{0000 -000 0000 -000}
87h
TRISB
PORTB Data Direction Register
1111 1111 1111 1111
0Eh
TMR1L Holding register for the Least Significant Byte of the 16-bit TMR1 register
xxxx xxxx uuuu uuuu
0Fh
TMR1H Holding register for the Most Significant Byte of the 16-bit TMR1register
xxxx xxxx uuuu uuuu
10h
T1CON
—
— T1CKPS1 T1CKPS0 T1OSCEN T1SYNC TMR1CS TMR1ON ^{--00 0000 --uu uuuu}
15h
CCPR1L Capture/Compare/PWM register1 (LSB)
xxxx xxxx uuuu uuuu
16h
CCPR1H Capture/Compare/PWM register1 (MSB)
xxxx xxxx uuuu uuuu
17h
CCP1CON _—
— CCP1X CCP1Y CCP1M3 CCP1M2 CCP1M1 CCP1M0 ^{--00 0000 --00 0000}
Legend: x = unknown, u = unchanged, - = unimplemented read as '0'. Shaded cells are not used by Capture and Timer1.
 2003 Microchip Technology Inc.
Preliminary
DS40300C-page 63