PIC24F08KA102-I Datasheet, PDF (59/278 Pages) Microchip Technology – 20/28-Pin General Purpose, 16-Bit Flash Microcontrollers with nanoWatt XLP Technology

PIC24F16KA102 FAMILY
REGISTER 7-1: RCON: RESET CONTROL REGISTER⁽¹⁾ (CONTINUED)
bit 3
SLEEP: Wake-up from Sleep Flag bit
1 = Device has been in Sleep mode
0 = Device has not been in Sleep mode
bit 2
IDLE: Wake-up from Idle Flag bit
1 = Device has been in Idle mode
0 = Device has not been in Idle mode
bit 1
BOR: Brown-out Reset Flag bit
1 = A Brown-out Reset has occurred (the BOR is also set after a POR)
0 = A Brown-out Reset has not occurred
bit 0
POR: Power-on Reset Flag bit
1 = A Power-up Reset has occurred
0 = A Power-up Reset has not occurred
Note 1:
2:
All of the Reset status bits may be set or cleared in software. Setting one of these bits in software does not
cause a device Reset.
If the FWDTEN Configuration bit is ‘1’ (unprogrammed), the WDT is always enabled, regardless of the
SWDTEN bit setting.
TABLE 7-1: RESET FLAG BIT OPERATION
Flag Bit
Setting Event
TRAPR (RCON<15>)
Trap Conflict Event
IOPUWR (RCON<14>)
Illegal Opcode or Uninitialized W Register Access
CM (RCON<9>)
Configuration Mismatch Reset
EXTR (RCON<7>)
MCLR Reset
SWR (RCON<6>)
WDTO (RCON<4>)
RESET Instruction
WDT Time-out
SLEEP (RCON<3>)
IDLE (RCON<2>)
BOR (RCON<1>)
PWRSAV #SLEEP Instruction
PWRSAV #IDLE Instruction
POR, BOR
POR (RCON<0>)
POR
DPSLP (RCON<10>)
PWRSAV #SLEEP instruction with DSCON <DSEN> set
Note: All Reset flag bits may be set or cleared by the user software.
Clearing Event
POR
POR
POR
POR
POR
PWRSAV Instruction, POR
POR
POR
—
—
POR
 2008-2011 Microchip Technology Inc.
DS39927C-page 59