PIC16LF819-I Datasheet, PDF (124/176 Pages) Microchip Technology – Enhanced Flash Microcontrollers with nanoWatt Technology

PIC16F818/819
15.2 DC Characteristics: Power-Down and Supply Current
PIC16F818/819 (Industrial, Extended)
PIC16LF818/819 (Industrial) (Continued)
PIC16LF818/819
(Industrial)
Standard Operating Conditions (unless otherwise stated)
Operating temperature
-40°C ≤ TA ≤ +85°C for industrial
PIC16F818/819
(Industrial, Extended)
Standard Operating Conditions (unless otherwise stated)
Operating temperature
-40°C ≤ TA ≤ +85°C for industrial
-40°C ≤ TA ≤ +125°C for extended
Param
No.
Device
Typ Max Units
Conditions
Supply Current (IDD)^(2,3)
PIC16LF818/819 72 95 µA
-40°C
76 90 µA
+25°C
VDD = 2.0V
76
90
µA
+85°C
PIC16LF818/819 138 175 µA
-40°C
136 170 µA
136 170 µA
+25°C
+85°C
VDD = 3.0V
FOSC = 1 MHZ
(RC Oscillator)⁽³⁾
All devices 310 380 µA
-40°C
290 360 µA
280 360 µA
+25°C
+85°C
VDD = 5.0V
Extended devices 350 500 µA
+125°C
PIC16LF818/819 270 315 µA
-40°C
280 310 µA
+25°C
VDD = 2.0V
285 310 µA
+85°C
PIC16LF818/819 460 610 µA
-40°C
450 600 µA
450 600 µA
+25°C
+85°C
VDD = 3.0V
FOSC = 4 MHz
(RC Oscillator)⁽³⁾
All devices 900 1060 µA
-40°C
890 1050 µA
890 1050 µA
+25°C
+85°C
VDD = 5.0V
Extended devices .920 1.5 mA
+125°C
Legend:
Note 1:
2:
3:
Shading of rows is to assist in readability of the table.
The power-down current in Sleep mode does not depend on the oscillator type. Power-down current is measured with
the part in Sleep mode, with all I/O pins in high-impedance state and tied to VDD or VSS and all features that add delta
current disabled (such as WDT, Timer1 Oscillator, BOR, etc.).
The supply current is mainly a function of operating voltage, frequency and mode. Other factors, such as I/O pin loading
and switching rate, oscillator type and circuit, internal code execution pattern and temperature, also have an impact on
the current consumption.
The test conditions for all IDD measurements in active operation mode are:
OSC1 = external square wave, from rail-to-rail; all I/O pins tri-stated, pulled to VDD;
MCLR = VDD; WDT enabled/disabled as specified.
For RC oscillator configurations, current through REXT is not included. The current through the resistor can be estimated
by the formula Ir = VDD/2REXT (mA) with REXT in kΩ.
DS39598E-page 122
 2004 Microchip Technology Inc.