E3A-JA3A-F11 Datasheet, PDF (7/60 Pages) Magnetrol International, Inc. – Liquid Level Displacer Transmitter

2.0 QuickStart Installation
2.1 Getting Started
2.1.1 Equipment and Tools
No special equipment or tools are required to install
E3 Modulevel. The following items are recommended:
• Wrenches, flange gaskets and flange bolting appropriate for
process connection(s)
• Flat-blade screwdriver
• Level
• ¹â„8" Allen wrench
• Fieldbus compatible power supply with proper termination
2.1.2 Configuration Information
Some key information is needed to configure the E3
Modulevel transmitter. Complete the following operating
parameters table before beginning configuration.
Display
LvlUnits
Question
What units of measurement will be used?
Answer
Lvl Ofst
Proc SG
What is the desired level reading when the
level is at the calibrated zero reference
(typically bottom of the displacer)?
What is the actual SG of the process liquid at
operating temperature?
ProcTemp What is the actual operating temperature?
2.2 QuickStart Mounting
NOTE: Confirm the style and process connection size/type of the
E3 Modulevel transmitter. Ensure it matches the requirements
of the installation before continuing with the QuickStart instal-
lation.
2.2.1 Tank Top
1. If applicable, adjust and trim the adjustable hanger cable
assembly to the required length and mount it between the
stem and displacer.
2. Using a level, verify that the vessel mounting flange is level
in all directions within 3°.
48-640 E3 Modulevel Displacer Level Transmitter - FOUNDATION fieldbus^™
7