1-66740-1 Datasheet, PDF (61/100 Pages) Tyco Electronics – M Series Pin and Socket Connectors

AMP M Series
Pin and Socket Connectors
NOTE: All part numbers
are RoHS Compliant
Special Application Connectors
Special Application
Connectors are available in
the following configurations:
V.35
Shallow Block
High Current
Mixed
High Voltage
RFI/EMI Shielded
Grounding Blocks
V.35 Connector
The 34 position V.35
Connector is fully assembled
and ready for placement on a
printed circuit board. They are
also available in kit form for
cable assembly. These
AMP V.35 connectors meet
the requirements of 408-2593
for CCITT V.35 interfacing.
High current connectors are
designed for applications
requiring up to 25 amperes of
current. They are available in
12-position male and female
housings which have rectan-
gular contact cavities for
accepting Type XII contacts.
Mixed connectors are
designed for applications that
require intermixing signal,
power and/or coaxial circuits
in the same connector
housing. Housings are avail-
able in 15-, 16-, 29 CF
(center fastener) and
42-position sizes and,
depending upon the specific
configuration, will accept
Multimate contacts, Type I
and Miniature, Standard and
Twin Standard COAXICON
contacts. The rectangular
contact cavities accept
Type XII contacts.
High voltage connectors are
designed for high voltage
applications using Multimate
contacts. The cavity centerline
spacings and the silo con-
struction of the contact
cavities increase the current
creepage path for higher volt-
age ratings. Housing sizes
include 20 and 28 positions.
RFI/EMI shielding kits
provide shielding capabilities
against radio frequency and
electromagnetic interferences.
Special 104-position housings
accept Multimate contacts
and are especially designed
for use with shielding hard-
ware. These shielding kits
cannot be used with the
standard 104-position
connector housings.
Grounding blocks are
ideally suited for aircraft appli-
cations, where shielded cable
is to be grounded to an air-
frame. The ground wires of
shielded cables are pigtailed
off with ferrules and are
crimped to Size 16 socket con-
tacts. The contacts are loaded
into a standard 14- or 34-posi-
tion connector housing. This
connector then can be mated
to the grounding block which
is fastened to the aircraft
frame. Grounding blocks have
Size 16 screw-machined pin
contacts which are staked, riv-
eted and soldered into the
L-shaped metal bracket. The
bracket has fixed jackscrew
receptacles that will accept
the special turnable jack-
screws fastened to the mating
socket connector half.
61
Catalog 82003
Dimensions are in millimeters
Dimensions are shown for USA: 1-800-522-6752
South America: 55-11-3611-1514
Revised 06-08
and inches unless otherwise
reference purposes only. Canada: 1-905-470-4425
Hong Kong: 852-2735-1628
specified. Values in brackets are Specifications subject
Mexico: 01-800-733-8926
Japan: 81-44-844-8013
www.tycoelectronics.com equivalent U.S. Customary Units. to change.
C. America: 52-55-5-729-0425 UK: 44-141-810-8967