E1993A Datasheet, PDF(7/40 Page) Keysight Technologies

English

English German Russian Spanish Italian Polish Chinese Japanese Korean French Portuguese	Language :

E1993A Datasheet, PDF (7/40 Pages) Keysight Technologies – W-CDMA Mobile Test Application

◁

07 | Keysight | E1963A W-CDMA Mobile Test Application - Technical Overview

HSPA/HSPA+ Specifications

(E1963A Option 403, 405, 413, 423, 433, and 435)

Call connection types

HSPA FDD test mode

HSPA FDD test modes are supported by the E1963A. FDD test mode provides Layer 1

functionality only. No higher-level signaling is provided or accepted. No higher-level call

processing operations are performed. The test set assumes that you have appropriately

configured the UE.

FDD test mode allows you to test the parametric performance of your UEâs transmitter and

receiver without call processing. In FDD test mode, the test set does not send any signaling

information on the downlink. Rather, it continuously generates a downlink signal and searches

for a corresponding uplink signal. The UE must synchronize to the downlink signal and send

an appropriate uplink signal, which the test set uses to measure the UEâs transmitter and

receiver performance. Any changes to the UE configuration must be accomplished by directly

sending commands to the UE from a system controller through a proprietary digital interface.

http://wireless.keysight.com/rfcomms/refdocs/wcdma/wcdma_gen_bse_fddtest.html

FRC H-set support

H-Set

3/3A

6/6A

8/8A

10/10A

Modulation

QPSK, 16QAM

QPSK

QPSK, 16QAM

64QAM

16QAM, QPSK

QPSK, 16QAM

64QAM, 16QAM

QPSK

Nominal avg. inf. bit rate (Mbps)

0.534, 0.777

0.801, 1.166

1.601, 2.332

0.534

0.801

3.219, 4.689

13.252

8.784, 4.868

4.86, 8.774

13.300, 8.774

0.06

Note: For DC-HSDPA H-Sets 3A, 6A, 8A, 10A and 12, the nominal avg. inf. bit rate is for each of the serving

cells. For HSDPA MIMO H-Sets 9 and 11, the nominal avg.inf. bit rate is for each of the transport blocks.

HSPA RB test mode

RB test mode uses signaling to establish a test control connection between the test set and

UE, allowing you to test the parametric performance of your UEâs transmitter and receiver.

In RB test mode, the test set provides signaling to establish a connection between the UE

and the test set. The test set can also signal the UE to change its configuration and alter the

uplink signal. The test set measures the uplink signal to determine the UEâs transmitter and

receiver performance. RB test mode is operated on the downlink, simultaneously supporting

a symmetrical RMC (reference measurement channel) of 12.2 kbps. This symmetrical RMC is

typically used for transmitter testing and receiver testing using BER.

http://wireless.keysight.com/rfcomms/refdocs/wcdma/wcdma_gen_bse_rbtest_setup.html

▷