E1993A Datasheet, PDF (3/40 Pages) Keysight Technologies – W-CDMA Mobile Test Application

03 | Keysight | E1963A W-CDMA Mobile Test Application - Technical Overview
Key Capabilities
–– CS voice handovers between GSM and W-CDMA on two test sets
–– Fast device calibration across level and frequency simultaneously
–– Test HSDPA MIMO devices (HS-DSCH categories 15-20) as defined in 3GPP TS 34.121-1
–– Test devices that support downlink dual carrier and dual band dual carrier
(HS-DSCH categories 20-24)
–– Test HSPA devices (HS-DSCH categories 1-14, 17-18 and E-DCH categories 1-7)
as defined in 3GPP TS 34.121-1
–– Switch between HSPA sub-test conditions while on an active connection
–– Test all UMTS technologies with one connection maintained throughout
–– Test all frequency bands I through XIV, XIX, XX, and XXI
–– FM and GPS receiver calibration in one box
–– Test vocoder speech quality using the industry standard PESQ algorithm
Tx measurements
Thermal power
Channel power
Adjacent channel leakage ratio
Waveform quality
Spectrum emission mask
Phase discontinuity
Inner loop power
Occupied bandwidth
Code domain power
IQ constellation
Tx on/off power
Frequency stability
Dynamic power analysis
Tx dynamic power
Spectrum monitor
Rx measurements
Loopback BER
BLER on DPCH (W-CDMA)
HBLER on HS-DPCCH (HSDPA)
W-CDMA
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
W-CDMA
Yes
Yes
N/A
HSDPA
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
HSDPA
N/A
N/A
Yes
HSUPA
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
HSUPA
N/A
N/A
N/A